GT Engine Standard Bearing Kit

£150.00

Comprehensive bearing, seal and ancillaries kit for any Lambretta engine build.

In stock

Description

The GT bearing kits are intended for people who have bought a GT engine case, but the kit can be used on any standard type engine case build.

The bearing kit consists of:

  • Engine mounts X 2
  • Drive bearing 6305 X 1
  • Mag bearing nu2205 X 1
  • Oil seal set
  • Rear brake cam grease nipple X 1
  • Rear axle bearing X 1
  • Rear axle needle bearing X 1
  • Rear axle needle bearing race X 1
  • Rear axle shim X 1
  • Lay gear needle bearing X 1
  • Lay gear needle bearing race X 1
  • Lay gear needle bearing shim X 2
  • Lay gear end plate bearing 6004 X 1
  • GT gasket set  X 1
  • Rear axle bearing retaining plate (thin) X 1
  • Rear axle bearing retaining plate (thick) X 1
  • Oil thrower X 1
  • Clutch tab washer X 1
  • Chain tab washer X 1
  • Internal Mag Wire Plate X 1
  • Sprung brake shoe plate X 1
  • Thick brake shoe plate X 1
  • Rear brake cable guide X 1
  • Rod shim X 4
  • Rear brake cable top hat X 1
  • Kick start outer cir clip
  • Kick start rubber stop X 1
  • Flywheel woodruff key  1
  • Assorted circlip X 4

Additional information

Weight 1.7 kg
Dimensions 30 × 20 × 16 cm
Gasket set type

200/240 (large block), 186 (small block)

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

You may also like…